Web-based Configuration Guide AP Management
106
If a large number of users access the AP or router, the wireless network
performance of the AP or router may be degraded, affecting users' Internet
access experience. After you set this parameter, new user access is prohibited
when the number of access users reaches the specified value. If the clients
require high bandwidth, you can adjust this parameter to a smaller value. You
are advised to keep the default value unless otherwise specified.
When multiple Wi-Fi signals are available, you can set this parameter to
optimize the wireless signal quality to some extent. When a client is far away
from the wireless device, the Wi-Fi connection is disconnected when the
wireless signal strength of the end user is lower than the kick-off threshold. In
this case, the client has to select a nearer wireless signal.
The client is prone to be kicked off if the kick-off threshold is high. To ensure that
the client can normally access the Internet, you are advised to set this
parameter to Disable or a value smaller than -75 dBm.
Note
Wireless channels available for your selection are determined by the country/region code. Select the
country/region code based on the country or region of your device.
Channel, transmit power, and roaming sensitivity cannot be set globally. Please perform the configurations
on the devices separately.
To Next Page
Loading...
Need help?
General
