EasyManua.ls Logo

SABB MOTOR 2H - Maintenance Schedule; Scheduled Maintenance Tasks

SABB MOTOR 2H
142 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-'
The manufacturer recommends the use of mono:-grade oil (SAE 10. SAE 20 or
SAE 30.) Multi-grade oil (SAE 10/30) should not be used.
LUB.OIL VISCOSI1Y AT AMBIENTTEMPERATURES SUMPCAPACITY
QUALITY Below +IO"C +10to +30" C Above +30°C 0il01ange Incl. OilFilter
(SO°F) ( (86°F)
. 4litres 4.5 litres
Service CD SAE 10 SAE 30 (7 pints) (8 pints)
The following makes and grades may e used (as may other makes of corresponding
quality): r-O
~O-~
HP Energol DS3 Mobil Delvac 1300
Chevron Delo 300 Motor Oil Ocean Diesoline 3
Castrol Devsol RX Super Reginol CD-SD
Essolube XD-3 Shell Super Marine Oil
Fina Solna S3 Texaco Ursa S3
Gulfpride Series 3
Use the same oil for clutch/ gearbox.
IMPORTANT:
If the engine bas been wholly or partly immersed in
water, all oil in the crankcase and clutch housing (or
~gearbox) must be changed immediately.
.1
1). DIPPING ENGINE OIL (Daily):
1. Withdraw dipstick (1) and wipe clean.
2. Insert dipstick fully and withdraw to read oillevel.
Repeat if necessary .
3. The oillevel must never he allowed to fall below the J
0( lower mark on the dipstick. If necessary, top up so ~o
that level is at upper mark. ""'
4. Replace dipstick and screw home.
If the engine is mounted at an angle exceeding 8
degrees the oillevel when the sump is full (4 litres)
wililie above the upper mark on the dipstick. The .
oillevel should normally lie between the two marks. Fig. 13
16

Table of Contents

Other manuals for SABB MOTOR 2H

Related product manuals