SABB MOTOR 2H - Filter Replacement and Greasing; Engine Oil Filter Change; Recommended Greases

10. GREASING OF PROPELLER CONTROL (Weekly):
The engine, including clutch/
~propeller control, bas 5 niples lor "
grease ~n lubrication (see lig) I
2H-2HSP. -""
1. Sliding bolts: t 2
2 shots with grease gun.
\\2. Oil Seals: t:
2 shots with grease gun.
3. Propellercontrol hearing: -
2 shots with grease gun.
!;: 4. Propeller controllever:
2 shots every 50-100 hours running.
S. Qutch lever:
2 shots every 50-100 hours running. Fig. 21
11. GREASING OF GEARBOX SEALS (Weekly): :
The rear sealing rings (6) should be I ti
lubricated weekly, 2 shots with a ~
grease ~n or until grease emerges c
round the wear ring. '
IMPORTANT:
If there is so much water in the boat
that it covers the sealing rings, the
boat should be pumped out before
operating the gearbox.
Fig. 22
21