""CC,ccc, .
GREASING OF AUXILIARY EOUIPMENT .'
12. Greasing of Starter Pinion (as required):
The starter must not be subjected to
water spray off the starter ring.
(See page 11.)
If the bendix pinion becomes rusted,
~ the starter should be removed (or
I sprayed with oil) and the starter pinion
~ r greased.
'f4;C-L-~ 1. Disconnect the electricalleads and
.1 Q rr:" unscrew the starter hom the engine.
. . 2: Insert a screwdriver (1) behind the
3 2 1 pinion (2). Lever the starter pinion
out while turning it clockwise.
Fig. 23 . 3. Apply grease (or lubricating oil) to
the shaft (3) and the starter pinion.
Turn the pinion to and from until it
moves freely in its track.
4. Assembie and fit the starter. Recon-
nect electricalleads and battery.
13. Lubrication of Remote Control
Lever (as required):
Apply oil or grease reguiarly to the rack
drive as shown in the figure.
Fig. 24
14. Greasing of Remote Control
(as required):
! The drive block on the end of the telescope
tube is free to move on its securing bolt
and this nipple (1) should he greased regu-
~arly to ensure the easiest possible manoeuvr-
fig.
Cables for propeller pitch, clutch or reverse
gearbox control, redder control cables and
cable guides should he coated with grease
during installation.
Fig. 25 J. Suitable grease: Esso Beacon ]00 EP.
22
To Next Page
Loading...
