Sabio 2010D - Page 111

Serial Communications Page 7-
9
_________________________________________________________________
Response Start The character that initiates a response
when data is returned. The <CR> character
is the default for the ML protocol.
Acknowledge The response character that acknowledges
the execution of a command when no data is
returned. The <ACK> character is the
default for the ML protocol.
Negative Acknowledge The response character that indicates that
there was a problem responding to the
command. The <NAK> character is the
default for the ML protocol.
Command End The end-of-command character. The <CR>
character is the default for the ML
protocol.
Field separator The character used to separate parameter
or data fields in commands and responses.
The comma character is the default for the
ML protocol.
Configuring the Computer for Terminal Mode
The computer's terminal emulation program must be configured
before a successful remote connection can be made. Following
are several considerations and descriptions of how to set up
each item in Procomm for DOS. For more details, refer to the
terminal program's documentation.
The following items can be configured in Procomm for DOS by
entering the Line/Port Setup screen with the ALT-P command:
Comm Port Select the comm port (usually COM1 or
COM2) to which the Model 2010D or modem is
attached.