Sagem RT3000 - CLIR On;Off Settings; PIN Number Management

Parameters in the file para.ini: advanced configuration
SAGEM RT3000 99
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
Section: <Provider>
Meaning Provider name Permitted Values Factory Setting
Predefined Provider T-D1 PDP_CONTEXT 1,"IP","internet.t-
d1.de","0.0.0.0",0,0
Predefined Provider D2 PDP_CONTEXT 1,"IP","volume.d2gprs.d
e","0.0.0.0",0,0
Predefined Provider EPLUS PDP_CONTEXT 1,"IP","internet.eplus.de"
,"0.0.0.0",0,0
Predefined Provider VIAG PDP_CONTEXT 1,"IP","internet","0.0.0.0"
,0,0
New Provider i.e. myGPRS PDP_CONTEXT PDP context as given by
the new provider.
16.22 CLIR on/off
Can be configured by SMS (see page 82)
Can be configured by FTP (see page 83)
Can be configured by DTMF (see page 80)
When you make a call your telephone number will be presented to the remote party
when this function is supported by the network. You can disable this function by setting
the following parameter:
CLIR=NO.
Section: MOBILE_CONFIG
Meaning Parameter Permitted Values Factory Setting
Enable CLIR CLIR YES, NO YES
16.23 PIN number
Can be configured by SMS (see page 82)
Can be configured by FTP (see page 83)
Can be configured by DTMF (see page 80)
The PIN number is stored in the parameter SIMPIN=<Pinnumber>.
Section: MOBILE_CONFIG
Meaning Parameter Permitted Values Factroy Setting
SIM PIN SIMPIN empty