Sagem RT3000 - Power-Missing SMS

Parameters in the file para.ini: advanced configuration
86 SAGEM RT3000
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
Section: DEVICE_ACCESS
Meaning Parameter Permitted Values Factory
Setting
Activate SMS config SMS_CONFIG YES, NO YES
PWD for config SMS DEVICE_PASSWORD 000000 to 999999 000000
Activate CLIP check SMS_CLIP=YES YES, NO YES
CLIP for Remote SMS SERVICE_CLIP_0 100 digits
CLIP for Remote SMS SERVICE_CLIP_1 100 digits
CLIP for Remote SMS SERVICE_CLIP_2 100 digits
CLIP for Remote SMS SERVICE_CLIP_3 100 digits
CLIP for Remote SMS SERVICE_CLIP_4 100 digits
Section: REMOTE_ACCESS
Meaning Parameter Permitted Values Factory
Setting
CLIP for Remote CSD SERVICE_CLIP_0 100 digits
CLIP for Remote CSD SERVICE_CLIP_1 100 digits
CLIP for Remote CSD SERVICE_CLIP_2 100 digits
CLIP for Remote CSD SERVICE_CLIP_3 100 digits
CLIP for Remote CSD SERVICE_CLIP_4 100 digits
Section: SERVICE_IF
Meaning Parameter Permitted Values Factory Setting
See 15.3 USER 100 chars service
See 15.3 PASSWORD 100 chars service
16.3 Power-missing SMS
Can be configured by SMS (see page 82)
Can be configured by FTP (see page 83)
If the mains power fails, the SAGEM RT3000 can send an SMS to a GSM telephone
number, which has to be pre-configured in the parameter file.
The function is activated by
[DEVICE_ACCESS]
POWER_REPORT=YES
POWER_REPORT_NR=<SMS Phone Number for Power Report>