Configuration of Tones
112 SAGEM RT3000
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
17 Configuration of Tones
Tones generated by the RT3000 can be configured by editing the parameter file
tone.ini. You can access this file in the same way as the parameter file para.ini. Refer
to page 83.
TONES
In the section TONES The frequencies of all available slic
generated tones can be defined. Entering invalid values will
provoke the default settings. You can define the following tones:
Telephone port
default
[Hz]
Phone/Fax/Modem port
default
[Hz]
Dial tone CHA_DIAL_TONE 425 CHB_DIAL_TONE 425
Ring back tone CHA_CALL_CTRL 440 CHB_CALL_CTRL 440
Busy tone CHA_BUSY_TONE 425 CHB_BUSY_TONE 425
Call wait tone CHA_CALL_WAIT 440 CHB_CALL_WAIT 440
Programming
acceptance tone
CHA_ACPT_PROG 950 CHB_ACPT_PROG 950
Programming non-
acceptance tone
CHA_NACPT_PROG 300 CHB_NACPT_PROG 300
PIN last try tone CHA_PIN_LAST 600 CHA_PIN_LAST 600
SIM missing tone CHA_SIM_MISS 950 CHB_SIM_MISS 950
Available frequencies are in the range from 300Hz up to 1500Hz in steps of 5Hz.
Example: CHA_DIAL_TONE=425 sets the frequency for the dial tone of channel A to
425 Hz
TONE_LEVEL
In the section TONE_LEVELS, the gain of the generated tones on
the SLIC ports can be defined. Following parameters are available
in this section for the tone gain on channel a and b.
Telephone port
default
[dB]
Phone/Fax/Modem port
default
[dB]
Level CHA_TONE_LEVEL 0 CHB_TONE_LEVEL 0
Available gains are in range from 0dB down to –30dB in steps of 1dB.
Example: CHA_TONE_LEVEL=0 sets the gain to 0dB for channel A
To Next Page
Loading...