Sagem RT3000 - Additional Configuration; Enable;Disable CLIR (Calling Line Identification Restriction); Dialling Timeout

Configuration
36 SAGEM RT3000
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
8.7 Additional Configuration
8.7.1 Enable/Disable CLIR (Calling Line Identification Restriction)
(CLIR = Calling Line Identification Restriction) When you are making a call, your
telephone number will be displayed to the called party, if there is the right equipment
available.
To change the setting enter the following sequence:
Description:
*5 ACCESS 007 0 #
Phone number will
not
be displayed to
called party
*5 ACCESS 007 1 #
Phone number will
be
displayed to
called party
8.7.2 Dialling Timeout
The SAGEM RT3000 must wait until you have dialled the complete telephone number
before it will establish the connection to the remote station. To detect the end of your
dialling it waits for a certain duration of time (the dial timeout) after each entered digit.
If you do not enter a further digit during this dial timeout the device "thinks" that you
have finished to enter the dial sequence and so it will start to establish the connection.
You can configure the duration of this period of time (dial timeout):
(Default: 600 = 6 sec.)
For the Telephone port:
Description:
*
5
A
CCESS
0
05 TTTT #
Dial Timeout
For the Fax/Modem/Phone port:
Description:
*
5
A
CCESS
0
06
T
TTT
#
Dial Timeout
Default access code:
000000
Default access code:
000000
Default access code:
000000