Sagem RT3000 - Configuration by DTMF

Configuration methods
80 SAGEM RT3000
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
15.1 Configuration by DTMF
The parameter values in para.ini may be changed by DTMF codes sent by a telephone
connected to the Telephone port or the Fax/Modem/Phone port. The configuration by
DTMF is limited to those parameters the user may change most likely according to his
operation needs.
The inputs always have the following format:
*5 ACCESS PAR XXXXXX #
Command ID Access code Parameter no. Value Save
*5
The command prefix informs the device that a configuration
setting is to be made.
ACCESS
The Access code (DTMF PASSWORD) protects your
configuration against intervention by others. Default: 000000
The command ID and the access code together ensure that
accidental incorrect inputs do not change your configuration.
PAR
You use the 3-digit command ID to specify which parameter you
wish to set.
XXXX
These digits (max. 6) set the new value for this parameter.
#
This character is the signal that the command ends here.
When entering DTMF tones using a connected analogue telephone correct entries are
acknowledged by an Accepted Programming Tone. If the input is incorrect you hear the
Non Accepted Programming Tone.
Example:
*5 ACCESS 001 15#
(sets in para.ini in section [DIALING] the parameter CHA_TX_VOICE_LEVEL to 15dB)
The table below shows the parameters that can be configured by DTMF codes. These
settings are described in chapter Configuration, page 22. The table shows the
command ID that is to be entered when using the telephone in order to set the
according parameter value. The table shows also the section and the name of the
parameters so that you can change the parameter settings by sending an SMS to the
SAGEM RT3000 or by editing the para.ini file