Sagem RT3000 - Analogue Data and Fax Call Prefixes; Local Accepted Emergency Numbers

Parameters in the file para.ini: advanced configuration
SAGEM RT3000 89
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
16.8 Prefix for Analogue Data and Fax calls
Can be configured by SMS (see page 82)
Can be configured by FTP (see page 83)
If your Analogue modem or fax machine dials either the fax or data prefix before the
telephone number, the RT3000 detects that it is an Analogue data or fax call and
switches in the correct mode. You can change these prefixes. Please ensure that your
chosen prefix differs from all DTMF configuration code.
Section: DIALING
Meaning Parameter Permitted Values Factory Setting
Force Analogue
data call
DATA_PREFIX Dial string of 3...6
characters
***
Force Analogue fax
call
FAX_PREFIX Dial string of 3...6
characters
###
16.9 Local accepted emergency number
Can be configured by SMS (see page 82)
Can be configured by FTP (see page 83)
The GSM standard does only allow a few Emergency call numbers. You may specify
up to 3 Emergency numbers, which will be translated into a GSM-valid Emergency
number automatically, if it is entered at the Phone or Fax/Modem/Phone port.
Example:
You have specified 111111 as the SAGEM RT3000 Emergency number. If this
number is dialled, the SAGEM RT3000 will translate this number to 112 which
is a official GSM-valid emergency number.
Section: CALL_MUX
This section includes mainly the parameter for call routing
Meaning Parameter Permitted Values Factory Setting
Local accepted
emergency number
EMERGENCY_1 40 digits 112
Local accepted
emergency number
EMERGENCY_2 40 digits -
Local accepted
emergency number
EMERGENCY_3 40 digits -