Sagem RT3000 - Operation: PC Fax Sending and Receiving

Operation: Using a PC to send and receive fax
SAGEM RT3000 59
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
11 Operation: Using a PC to send and receive fax
!
Your Personal Computer is directly connected to the SAGEM RT3000 via its RS-
232 port or its USB port. Make sure that you have installed the modem driver of the
SAGEM RT3000 (see, page 18). When you connect your PC to the USB port, then
the RS-232 port is switched off.
!
With the fax software installed on your computer you can send and receive fax
documents. The remote fax machine may be any facsimile device.
Your fax software must be compatible to fax class 1.
!
While you are sending or receiving a fax with your PC, the single “wireless”
telephone line of the SAGEM RT3000 will be engaged. You cannot make a
telephone call or send / receive a fax with your analogue facsimile device at the
same time.
!
By default a received fax comes in at the Fax/Modem/Phone port of the SAGEM
RT3000, so that a facsimile device connected to this port receives the fax. If you
want to receive fax documents by the PC connected to the SAGEM RT3000, you
have to make the corresponding setting. See Select Port for Fax Calls, page 31.