Sagem RT3000 - GPRS Configuration Settings

Parameters in the file para.ini: advanced configuration
98 SAGEM RT3000
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
16.21 GPRS Configuration
Can be configured by SMS (see page 82)
Can be configured by FTP (see page 83)
Can be configured by AT-command (see p. 62)
To set-up GPRS connections, the PDP_CONTEXT for this connection must be
specified in the para.ini file. For each GPRS provider an own section has to be created
in the parameter file. For some GPRS providers the configuration is already pre-
configured:
[T-D1]
PDP_CONTEXT=1,"IP","internet.t-d1.de","0.0.0.0",0,0
[D2]
PDP_CONTEXT=1,"IP","volume.d2gprs.de","0.0.0.0",0,0
[EPLUS]
PDP_CONTEXT=1,"IP","internet.eplus.de","0.0.0.0",0,0
[VIAG]
PDP_CONTEXT=1,"IP","internet","0.0.0.0",0,0
You can add a new GPRS provider by creating an own section for it:
[NEW-PROVIDER]
PDP_CONTEXT=<values for the new-Provider>
It is possible to add several of new providers by adding a corresponding number to the
new sections.
In the section [GPRS-CONFIG] you select the active provider:
[GPRS-CONFIG]
PROVIDER=NEW-PROVIDER
If you enter the APN by the AT command AT+CGDCONT=<APN>, this will overwrite
temporarily the parameter value of PROVIDER.
Section: GPRS_CONFIG
Meaning Parameter Permitted Values Factory Setting
Provider section
name
(predefined and
new)
PROVIDER existing section
name
(e.g.: T-D1)
Reserved SPECIAL_CGATT=NO