Sagem RT3000 - Ports and Voice Signal Volume

Configuration
SAGEM RT3000 23
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
8.2 Ports for incoming calls; volume of voice signal
8.2.1 To select ports for incoming telephone calls
By default, the Telephone port and the Fax/Modem/Phone port will RING when a call
comes in.
To change the setting enter the following sequence:
Incoming phone call
is signalled on:
*5 ACCESS 009 1 #
Only on Telephone
port
*5 ACCESS 009 2 #
Only on
Fax/Modem/Phone
port
*5 ACCESS 009 4 #
Telephone port and
Fax/Modem/Phone
port (Default)
8.2.2 Volume of voice signals in telephone calls
You can adjust the volume of the voice signal which is sent to the remote party. You
can also adjust the volume of the voice signal which is received from the remote party.
To change the setting enter the following sequence:
Telephone port:
Description:
*5 ACCESS 001 VV #
Volume sent to
remote party
*5 ACCESS 002 VV #
Volume of voice
signals received
from remote party
Default access code:
000000
Default access code:
000000