Sagem RT3000 - Operation: PC SMS Sending and Receiving

Operation: Using a PC to send and receive SMS
SAGEM RT3000 61
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
13 Operation: Using a PC to send and receive SMS
!
Your Personal Computer is directly connected to the SAGEM RT3000 via its RS-
232 port or its USB port. Make sure that you have installed the modem driver of the
SAGEM RT3000 (see, page 18). When you connect your PC to the USB port, then
the RS-232 port is switched off.
!
With a SMS-Software running on a PC connected to the SAGEM RT3000, you can
send and receive SMS (Short Message Service).
The SMS-Software must support the SMS AT commands listed in chapter 0.
!
By default an incoming SMS enters like any data call at the PC-port of the SAGEM
RT3000. So you can receive SMS by the PC connected at the RS-232 or USB port
of the SAGEM RT3000. If you want you can change this setting. See Select port to
receive SMS, page 32.