Sagem RT3000 - Call Waiting; Check Status for Call Forwarding, Call Barring and Call Waiting

Configuration
30 SAGEM RT3000
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
8.3.9 Call waiting
If the call waiting function is activated, during active telephone calls an incoming call
will be indicated by a signal tone.
To change the setting enter the following sequence:
Description:
*43#
Function activated
#43#
Function deactivated (Default)
*#43#
Check the status (see p. 30)
8.3.10 Check status for call forwarding, call barring and call waiting
When you check the status for call forwarding, call barring or call waiting, the status
will be indicated by signal tones from the telephone handset:
Description:
___ Beep ____ Beep
Status on / DTMF code correct
___ Beep _ Beep____ Beep
Status off / DTMF code correct
___ Beep_ Beep
DTMF code not correct or service not provided
by the network