Parameters in the file para.ini: advanced configuration
92 SAGEM RT3000
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
Fax Identification
[Can be configured by SMS, FTP] When you send a fax by your local fax
machine via the SAGEM RT3000 to a remote station, your local fax machine
will show the Fax Identification configured in this parameter. This is necessary
because of the special mechanism required to transmit the fax via the GSM
network. When receiving a fax with the local fax machine, the identification of
the remote fax machine will be shown.
IDENT=<RT3000>
16.12 Billing Tone configuration
Can be configured by SMS (see page 82)
Can be configured by FTP (see page 83)
The SAGEM RT3000 can generate billing pulses on the Telephone port and on the
Fax/Modem/Phone port.
Enable/Disable
This feature can be activated or deactivated for both ports separately
[CHA_BIILING_ENABLED, CHB_BIILING_ENABLED].
Text Pulse Frequency
The RT3000 can generate billing pulses with a frequency of
12kHz [CHx_16KHZ_BURST=No], or
16kHz [CHx_16KHZ_BURST=Yes].
Tax-pulse cadence
The duration of the tax-pulse can be selected with this parameter:
CHx_PULSE_DURATION
CHx_PULSE_DELAY
tax-pulse level
The tax-pulse signal level can be adjusted with the following parameter:
CHA_PULSE_LEVEL
e.g.: CHA_PULSE_LEVEL=2,5.
Section: BILLING
Meaning Parameter Permitted
Values
Factory Setting
Enable Billing Port A CHA_BILLING_ENABLED YES, NO YES
the tax-pulse duration
in x*10ms
CHA_PULSE_DURATION 1 to 100 20
the tax-pulse delay in
x*10ms
CHA_PULSE_DELAY 1 to 60000 100
To Next Page
Loading...