Sagem RT3000 - Connecting Telecom Equipment

Putting the device into operation
10 SAGEM RT3000
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
3.3 Connecting the telecomms equipment
To put the device into operation you have to connect at least
• the power supply so that the device gets power
• one telephone device, so that you can enter the PIN number.
Power Supply
Connect the Power Supply adapter here. Use only the Power
supply adapter supplied with the RT3000. Plug-in the Power
supply adapter into the mains socket.
RS232 (optional)
Connect this interface with the COM port (serial RS-232
interface) of your computer, if you want to have access to the
internet or if you want to use your computer for fax and data
communication. If you connect a device to the USB port, the RS-
232-Port will be deactivated.
Default settings:
Transmission speed 57,600 bps
Data bits 8
Parity N (none)
Stop bits 1
USB (optional)
If you want to connect your computer via its USB interface
instead of its COM port to the SAGEM RT3000, please first
install the drivers and then plug in the USB cable.
Telephone
You can connect here analogue telephones.
Fax/Modem/Phone
You can connect here analogue telecomm equipment, e.g.
analogue fax machine (or a combi fax), analogue modem or
analogue telephones
Power Supply
PC via RS232
Telephone
PC via USB
Fax machine, Modem
or Tele
p
hone