Sagem RT3000 - Call Forwarding if Not Accessible (CFNA)

Configuration
SAGEM RT3000 27
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
##61#
Deactivates call
forwarding if no answer
*#61#
Status Checking (see p.
30)
Meaning:
<Telnumber> = the telephone number, the call will be forwarded to
<delay_time> = the delay, after which the call is forwarded in seconds
<call_type> =
11
: Incoming phone calls will be forwarded.
<call_type> =
13
: Incoming fax calls will be forwarded.
<call_type> =
25
: Incoming data calls will be forwarded.
Both prefix commands
*
and
**
are supported to activate the service.
Both prefix commands
#
and
##
are supported to deactivate the service.
8.3.4 Call forwarding if not accessible (CFNA)
If call forwarding if not accessible is activated, incoming calls will be forwarded to the
configured telephone number, if your SAGEM RT3000 is not accessible in the GSM
network so that the call can not be answered by telephone, fax or data device. You can
configure this for each type of call (voice, data, fax) independently. You can also
configure the delay after the call is forwarded.
To change the setting enter the following sequence:
Description:
**62*
<Telnumber>
#
Activates for all call types
**62*
<Telnumber>
*
<call_type>
#
Activates for selected call
types (see below)
##62#
Deactivates call
forwarding if not
accessible
*#62#
Status Checking (see p.
30)
Meaning:
<Telnumber> = the telephone number, the call will be forwarded to
<call_type> =
11
: Incoming phone calls will be forwarded.
<call_type> =
13
: Incoming fax calls will be forwarded.
<call_type> =
25
: Incoming data calls will be forwarded.
Both prefix commands
*
and
**
are supported to activate the service.
Both prefix commands
#
and
##
are supported to deactivate the service.