Sagem RT3000 - Network Services Configuration

Configuration
24 SAGEM RT3000
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
Fax/Modem/Phone port:
To change the setting enter the following sequence:
Description:
*5 ACCESS 003 VV
#
Volume sent to
remote party
*5 ACCESS 004 VV
#
Volume of voice
signals received
from remote party
Meaning:
VV
= 00 .... 20
with 00 = maximum volume
with 20 = minimum volume
Factory setting: 07
Example:
You want to increase the volume of voice signals received from the remote party
when you use the Telephone port:
Lift up the handset
,
then enter:
*5 000000 002 03 #
and wait for the confirmation tone
,
then hang-up the handset
.
8.3 Configuration of network services
Your SAGEM RT3000 is a sophisticated device with a wide range of modes of
operation. You have to decide which operation modes are appropriate for your needs
and then enable them by configuring the SAGEM RT3000.
The configuration
process
Use a telephone connected to the Telephone port or the
Fax/Modem/Phone port of the RT3000 to enter a special
sequence (see below) just as you would dial a number. (The
telephone must use tone (= DTMF) dialling.)
The icons in the following descriptions mean:
listen to the confirmation tone:
a high pitched beep signals: OK
a low frequency beep-beep signals: Wrong entry.
You may have to wait 3 seconds before hearing the confirmation
tone.
lift up the handset.
Default access code:
000000