Configuration
22 SAGEM RT3000
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
8 Configuration
Your SAGEM RT3000 is a sophisticated device with a wide range of modes of
operation. You have to decide which operation modes are appropriate for your needs
and then enable them by configuring the SAGEM RT3000.
The configuration
process
Use a telephone connected to the Telephone port or the
Fax/Modem/Phone port of the RT3000 to enter a special
sequence (see below) just as you would dial a number. (The
telephone must use tone (= DTMF) dialling.)
The icons in the following descriptions mean:
listen to the confirmation tone:
a high pitched beep signals: OK
a low frequency beep-beep signals: Wrong entry.
You may have to wait 3 seconds before hearing the confirmation
tone.
lift up the handset.
hook on the handset.
ACCESS
means: access code; by default it is
000000
8.1 Access code for DTMF configuration
8.1.1 Changing the DTMF access code
The configuration of your SAGEM RT3000 is protected against unauthorised
modification by an access code. The access code is part of each DTMF configuration
code apart from the DTMF codes to configure call forwarding and call barring.
The access code consists of 6 numeric digits. The default value is
000000.
*5 OLDACC 023 NewACC #
It means:
OLDACC
: old access code
newACC
: new access code
To Next Page
Loading...