Sagem RT3000 - GSM Frequency Band Selection

Parameters in the file para.ini: advanced configuration
SAGEM RT3000 105
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
16.36 Frequency band selection GSM 900, DCS 1800, PCS 1900
Can be configured by SMS (see page 82)
Can be configured by FTP (see page 83)
Section: MOBILE_CONFIG
Meaning Parameter Permitted values Factory Setting
Selects the GSM
frequency band
BAND GSM
DCS
DUAL_EU
DUAL_US
ALL
ALL
Setting Meaning
GSM 900 MHz only
DCS 1800 MHz only
DUAL_EU Autoselect 900/1800 MHz
DUAL_US Autoselect 900/1900 MHz
ALL Autoselect 900/1800/1900 MHz
!
Do not change the factory
setting in the para.ini!
The RT3000 with 900/1800
MHz antenna should only be
used in 900 MHz or 1800 MHz
networks.
The RT3000 with 1900 MHz
antenna should only be used in
1900 MHz networks.
If you do not know, if your
GSM networks operates at
900/1800 MHz or at 1900 MHz
contact your GSM network
operator.
16.37 Identification
Section: GENERAL
Meaning Parameter Setting
Reserved PRODUCT_CODE DNT8115
Reserved VERSION_PARA_INI 1.026