Sagem RT3000 - Call Forwarding if Busy (CFB); Call Forwarding if no Answer (Cfnry)

Configuration
26 SAGEM RT3000
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
8.3.2 Call forwarding if busy (CFB)
If Call forwarding if busy is activated, incoming calls will be forwarded to the configured
telephone number, if the SAGEM RT3000 is just busy in performing a telephone, fax or
data call when calls come in. You can configure this for each type of call (voice, data,
fax) independently.
To change the setting enter the following sequence:
Description:
**67*
<Telnumber>
#
Activates for all call types
**67*
<Telnumber>
*
<call_type>
#
Activates for selected call
types (see below)
##67#
Deactivates call
forwarding if busy
*#67#
Status Checking (see p.
30)
Meaning:
<Telnumber> = the telephone number, the call will be forwarded to
<call_type> =
11
: Incoming phone calls will be forwarded.
<call_type> =
13
: Incoming fax calls will be forwarded.
<call_type> =
25
: Incoming data calls will be forwarded.
Both prefix commands
*
and
**
are supported to activate the service.
Both prefix commands
#
and
##
are supported to deactivate the service.
8.3.3 Call forwarding if no answer (CFNRy)
If call forwarding if no answer is activated, incoming calls will be forwarded to the
configured telephone number, if the call is not answered by a connected telecomms
equipment. You can configure this for each type of call (voice, data, fax) independently.
You can also configure the delay after the call is forwarded.
To change the setting enter the following sequence:
Description:
**61*
<Telnumber>
#
Activates for all call
types
**61*
<Telnumber>
**
<delay_time>
#
Setting the delay after
which the call is
forwarded for all call
types
**61*
<Telnumber>
*
<call_type>
#
Activates for the selected
call types (see below)
**61*
<Telnumber>
*
<call_type>
*
<delay_time>
#
Specifies the target
number, the call type
and the delay.