Sagem RT3000 - Page 114

Configuration of Tones
SAGEM RT3000 113
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
TIMINGS
In the section TIMINGS the user can define his own tone and ring
timings. For the following tones on channel a and b the timings
can be changed:
Sequence definition (default; [ms])
Telephone port t1 on t2 off t3 on t4 off t5 on Term
RING signal CHA_RING 100 400 - - - -2
Dial tone CHA_DIAL 100 0 - - - -2
Ring back tone CHA_CALL_CTRL 150 350 - - - -2
Busy tone CHA_BUSY_TONE 50 50 - - - -2
Call wait tone CHA_CALLWAIT 40 800 16 16 16 -4
Programming
acceptance tone
CHA_ACPT_
PROG
10 10 - - - -100
Programming non-
acceptance tone
CHA_NACPT_
PROG
10 50 10 50 - -100
PIN last try tone CHA_LAST_PIN 50 50 10 50 - -4
SIM missing tone CHA_SIM_MISS 10 50 - - - -2
Sequence definition (default; [ms])
Fax/Modem/Phone
port
t1 on t2 off t3 on t4 off t5 on Term
RING signal CHB_RING 100 400 - - - -2
Dial tone CHB_DIAL 100 0 - - - -2
Ring back tone CHB_CALL_CTRL 150 350 - - - -2
Busy tone CHB_BUSY_TONE 50 50 - - - -2
Call wait tone CHB_CALLWAIT 40 800 16 16 16 -4
Programming
acceptance tone
CHB_ACPT_
PROG
10 10 - - - -100
Programming non-
acceptance tone
CHB_NACPT_
PROG
10 50 10 50 - -100
PIN last try tone CHB_LAST_PIN 50 50 10 50 - -4
SIM missing tone CHB_SIM_MISS 10 50 - - - -2