Sagem RT3000 - Page 73

For experienced Users: AT commands
72 SAGEM RT3000
Datei 8115AD002-Total.doc
Datei gespeichert 24.04.04 13:23 von EDV/ORGA
Druckzeit 24.04.04, 18:17
Status Release
Values for:
<bm>
0
No CBM indications are routed to the TE.
1
Not supported
2
New CBMs are routed directly to the TE
using unsolicited result code:
CBM: <length><CR><LF><pdu> (PDU
mode enabled) or +CBM:
<sn>,<mid>,<dcs>,<page>,<pages>
<CR><LF><data> (text mode Enabled).
3
Class 3 CBMs are routed directly to TE
using unsolicited result codes defined in
<bm>=2.
Values for:
<ds>
0
No SMS-STATUS-REPORTs are routed to
the TE.
1
Not supported
2
Not supported
<bfr>
0
The buffered notification are sent.
1
Not supported
AT+CPMS – Selecting the SMS memory location:
AT+CPMS= <mem>
Sets the memory location
AT+CPMS?
Calls up the current memory location
AT+CPMS=?
Lists the memory locations supported
Values for:
<mem>
„SM“
SIM card
AT+CSCA – Setting the Service Center address:
AT+CSCA=<sca>[,<tosca>]
Sets the Service Center address
AT+CSCA?
Displays the address currently set
AT+CSCA=?
Lists the characters allowed for the
telephone number
Value for::
<sca>
“Service Center telephone number”
Value for:
<tosca>
129, 145