Sam4s ER-265 - Initial Clear

SAM4s ER-265 Operator's and Programming Manual v1.14 Quick Setup  21
Initial Clear
CAUTION: Do not share this information with unauthorized users. Distribute the S Mode
key only to those you may want to perform this function.
The initial clear function allows you to exit any register activity and return to a beginning or cleared
state. Any transaction that is in progress will be exited and totals for that transaction will not be
updated.
Here are some reasons you may want to perform an initial clear:
 The register is in an unknown state, and you wish to exit the current program or
transaction without following normal procedures.
 An initial clear may be necessary as part of servicing, or troubleshooting.
To Perform an Initial Clear:
1. Turn the power switch OFF.
2. Turn the control lock to the S position. (The S position is a hidden position one
position clockwise from the PRG position.)
3. Press and hold the CASH/TEND key and turn the power switch ON.
4. The message "****** INITIAL CLEAR ******” prints when the initial clear is
complete.