Sam4s ER-265 - Programming Plu Status

78  Advanced Programming Instructions SAM4s ER-265 Operator's and Programming Manual v1.14
Programming PLU Status
1. Turn the control lock to the PGM position.
2. Enter the number of the PLU you wish to program (1-1000), press the PLU key.
3. Decide if you want a negative, enforced non-add entry, or disabled PLU. If you do
not want any of these options, enter 0. If you wish to select any of these options,
complete the table below by adding the status digits for each option. Enter the
resulting digit.
PLU is Negative Yes = 1
No = 0
+
Enforce Non-Add
Entry
Yes = 2
No = 0
+
PLU is Disabled Yes = 4
No = 0
+
=
4. Decide if you want a preset or single item PLU. If you do not want any of these
options, enter 0. If you wish to select any of these options, complete the table below
by adding the status digits for each option. Enter the resulting digit.
PLU is Preset Yes = 1
No = 0
+
PL:U is Single Item Yes = 2
No = 0
+
=
5. Complete the tax status table below by adding the status digits for each tax. Then
enter the resulting tax status code.
Taxable by Rate 1? Yes = 1
No = 0
+
Taxable by Rate 2? Yes = 2
No = 0
+
Taxable by Rate 3? Yes = 4
No = 0
+
=
7. If you are using a kitchen printer and wish this item to print at the printer, select Yes
here.
Send KP? Yes = 1
No = 0
+
=
8. Press the department key that you want this PLUs’ sales added to.
9. Repeat steps 2 through 7 for each PLU you wish to program.