Sam4s ER-265 - System Option Programming

60  Advanced Programming Instructions SAM4s ER-265 Operator's and Programming Manual v1.14
System Option Programming
Thirty-one system options are provided so that you can configure the SAM4s ER-265 to your exact
requirements. Refer to the “System Option Table” on page 62 to review the system options. Read
each option carefully to determine if you wish to make any changes.
NOTE: Because after clearing memory all options settings are automatically set to 0, and
because your most likely option selections require a status setting of 0, you do not need to
program this section unless you wish to change the default status.
Programming a System Option:
1. Turn the control lock to the PGM position.
2. Enter the option number of the system option you wish to change. Press the RA key.
3. Enter the number representing the status you have selected. Press the PO key.
4. Repeat from step 3 for each system option you wish to change.
5. Press the CASH/TEND key to end programming.
System Option Flowchart
PO RA
Status
CASH/
TEND
Repeat for each
S
y
stem Option
Option #