48 Advanced Operating Instructions SAM4s ER-265 Operator's and Programming Manual v1.14
Totaling a Charge Sale
1. Register the items you wish to sell.
2. Press CHARGE:
CHARGE
3. The display will indicate “=” for total, the
drawer will open and the receipt will print
as in the example on the right.
Note: Charge tendering is not allowed.
THANK-YOU
CALL AGAIN
DEPT.1 T1 $2.99
DEPT.1 T1 $2.99
4 X $1.99
DEPT.2 $7.96
SUBTOTAL $14.30
TAXABLE1 $5.98
TAX1 AMOUNT $0.36
CHARGE $14.30
15:40 03-01-2006
000055 CLERK 1 00
Check Cashing
Check cashing means exchanging cash for a check. Normally, this function is not allowed. If you
wish to allow check cashing, you must set system option #15 to a value of 1. See “System Option
Programming” on page 60.
1. Enter the amount of the check tendered by
the customer. For example, for $20.00
enter:
0 0 0 2
2. Press CHECK TEND:
CHECK
TEND
3. The display will indicate “C” for change,
the drawer will open and the receipt will
print as in the example on the right.
THANK-YOU
CALL AGAIN
CHECK $20.00
CASH -20.00
15:40 03-01-2006
000056 CLERK 1 00
To Next Page
Loading...
