Sam4s ER-265 - Receipt On;Off and Receipt on Request

SAM4s ER-265 Operator's and Programming Manual v1.14 Advanced Operating Instructions  53
Receipt On/Off and Receipt on Request
When a receipt is not normally issued, you can turn the receipt function on or off.
If the receipt is off, you can still issue a receipt after the sale has been completed. Normally, this
function is not allowed. If you wish to allow after sale receipts, you must set system option #17 to
a value of 1. See “System Option Programming” on page 60.
To Turn the Receipt Off
 With the control lock in the REG position, press PO (Paid Out):
PAID
OUT
To Turn the Receipt On
 With the control lock in the REG position, press PO (Paid Out) again:
PAID
OUT
Printing a Receipt after the Sale
 After the sale has been totaled, but before the next transaction is started, press
CASH/TEND:
CASH/
TEND
Note: Because receipt memory is limited, when a sale has more than 30 items or more than 3
tenders, the receipt after sale can not print all items. A row of dots is printed indicating the
receipt is incomplete.