Sam4s ER-265 - PC Online Mode

92  Advanced Programming Instructions SAM4s ER-265 Operator's and Programming Manual v1.14
PC Online Mode
SAM4s provides an optional PC Utility for the ER-265. You can directly connect your ER-265 to a
personal computer and use the PC Utility at the PC to program, poll reports and download graphic
logos to the ER-265.
The ER-265 must be set in PC Online Mode before PC communications are possible:
1. Connect the PC to the ER-265 using one of the following cables:
CRS Part # 522035 (Register DB-9M to PC DB-9F)
CRS Part # 522038 (Register DB-9M to PC DB-25F)
2. Turn the control lock to the S position.
3. Press the RA key. The message “CC” will display in the center of the operator display.
(Note that while PC communications are taking place, the “CC” message will flash off and
on again.) The ER-265 is ready for communication.
4. Use the ER-265 PC Utility program to initiate communication. Refer the the separate
“SAM4s ER-265 PC Utility User’s Manual”.
5. Press the CLEAR key to exit PC Online mode.
Program Scan
You can print out a copy of your ER-265 program:
1. Turn the key to the PGM position.
2. Press the CASH/TEND key. The program data will print.
You can also generate a PLU program scan.
1. Turn the control lock to the PGM position
2. Enter 15 on the numeric keypad and press the SUB TOTAL key.
3. To read PLU program information, enter the number (1-1000) of the start PLU and press
the PLU key