Sam4s ER-265 - Program Overlay

88  Advanced Programming Instructions SAM4s ER-265 Operator's and Programming Manual v1.14
Program Overlay
Instead of entering descriptor codes, you can program descriptors using the alpha overlay as shown
below. Note that each position contains three characters.
 You will press a key once to select the first (left-most) character, twice to select the second,
or three times to select the third character. Then you will press the decimal key to enter
the character.
 If you wish to place a space between characters, touch Space and then the decimal key.
 If you wish to use “double size” characters, touch Double and then press the decimal key.
Then select the character, and press the decimal key again. Continue to touch Double, and
then decimal before every double-size character. Double size characters use two character
positions. In other words you can have 16-double size characters on a descriptor line
instead of 32-single sized characters.
Follow the detailed instructions on the next page.
Space Double Ü￡Ñ ØÁ€ ÍÓÚ
)*+ ,-sp |^~ ＼{} _.Dbl ÇÄÅ ÉÆÖ
ABC
1
DEF
6
GHI
11
JKL
2
MNO
7
PQR
12
7 8 9 CHECK
STU
3
VWX
8
YZ@
13
4 5 6
SUB
TOTAL
&#$
4
• /:
9
;<=
14
1 2 3
>?[
5
]!"
10
%'(
15
0 00 .
CASH
/
TEND