Sam4s ER-265 - Page 89

SAM4s ER-265 Operator's and Programming Manual v1.14 Advanced Programming Instructions  89
Programming Descriptors Using the Program Overlay
Note: You must set System Option #27 to a value of 1 to program descriptors using the
overlay method.
1. Turn the control lock to the PGM position.
2. Press the X/TIME key.
3. Enter up to 18 characters if you are programming departments/PLUs or enter up to 32
characters if you are programming a message line in the following manner.
A. Press a key once to select the first (left-most) character, twice to select the second,
or three times to select the third character. Then press the decimal key to enter
the character.
B. If you wish to place a space between characters, touch Space and then the decimal
key.
C. If you wish to use “double size” characters, touch Double and then press the
decimal key. Then select the character (by press a key once, twice or three
times), and press the decimal key again. Continue to touch Double, and then
decimal before every double-size character. Double size characters use two
character positions. In other words you can have 16-double size characters on a
descriptor line instead of 32-single sized characters.
4. After all characters are entered, press the X/TIME key.
5. If you are programming a PLU descriptor:
Enter the PLU code, press the PLU key.
If you are programming a Department descriptor:
Press the Department key you wish to set.
If you are programming a message line:
Enter the number representing the message line you are programming press the
CHECK key.
11 ~ 16 : 1
st
Line ~ 6
th
Line (Preamble Logo)
21 ~ 26 : 1
st
Line ~ 6
th
Line (Postamble Logo)
6. Press the CASH/TEND key to end programming.
Program Overlay Example
Set the descriptor ‘JUICE” for department #1.
1. Turn the control lock to the PGM position.
2. Press the X/TIME key.
3. Press DEPT 2, Decimal (J)
Press DEPT 3, DEPT 3, DEPT 3, Decimal (U)
Press DEPT 11, DEPT 11, DEPT 11, Decimal (I)
Press DEPT 1, DEPT 1, DEPT 1, Decimal (C)
Press DEPT 6, DEPT 6, Decimal (E)
4. Press the X/TIME key.
5. Press DEPT 1.
6. Press the CASH/TEND key to end programming.