SAM300 Reference Manual v1.0 Appendices 77
Starting Operations
YOU MUST DO THIS FIRST!
Before you can attempt communications or editing, you must create at least one
store. Refer to "Creating a New Store" on page 14.
After creating a store, you must Receive (Upload) information from the ECR.
Refer to "Receive Programs from ECR (Upload)" on page 41.
1. Start by uploading the memory allocations, do this by going into communications and
entering receive data or upload; check for all program data.
2. If memory allocation is successful, then communication settings are correct. You can
now check all and upload all programs.
3. If the above works, then you are ready to program either from the SAM300 software or
from the register.
To Next Page
Loading...
