Samson 3374 Series - Comment on Plausibility Error; Causes of Plausibility Error

EB 8331-4 EN 5-1
Installation
5 Installation
The work described in this section is only to be performed by personnel appropriately quali-
edtocarryoutsuchtasks.
5.1 Installation conditions
Work position
If not described otherwise in the valve documentation, the work position for the control valve
is the front view looking onto the operating controls.
Mounting orientation
Thecontrolvalvecanbeinstalledinthepipelineinanydesiredposition.However,asus-
pendedmountingpositionoftheactuatorisnotpermissible(seeFig.5-1).
 
!
0...90° 0...90°
Fig.5-1: Mounting position
5.2 Preparation for installation
Beforemounting,makesurethefollowingconditionsaremet:
− The actuator is not damaged.
Proceed as follows:
Lay out the necessary material and tools to have them ready during mounting.