Samson 3374 Series - 8 Operation; Automatic Mode; Information Level

EB 8331-4 EN 8-1
Operation
8 Operation
8.1 Automatic mode
The behavior of the actuator in automatic mode depends on the application selected (see the
'Design and principle of operation' section for a description).
A constant supply voltage must be applied to the actuator to allow it to operate (see the 'In-
stallation' section).
8.1.1 Information level
In the information level, all the actuator data important for closed-loop operation are dis-
played. Codes of the information level have an 'i'prextoidentifythem.
AlltheparametersoftheinformationlevelarelistedinAnnexA.
Activating parameters
Activate the information level
1. Turn (when the start screen appears) to select Code 11.
2. Press to activate the information level.
(display: i01).
Activating parameters
Î Turn
to activate the required code.
In this example:
Code i01, Lower range value of input signal (the
icon
stands for the mA unit).
Exit information level
1. Turn
to select the code i00 (ESC).
2. Press to exit information level.