Samson 3374 Series - Restart; Normal (c43 = NORM); Zero Calibration (c43 = ZERO); Fixed Positioning Value (c43 = FIX)

6-4 EB 8331-4 EN
Operating controls
6.1.2 Rotary pushbutton
Theoperatingcontrolsarelocatedunderneaththehousingcover(seeFig.6-1).
The settings are changed using the rotary pushbutton.
Turn
:select/changecodesandvalues
Press
:conrmsetting/change
Changed parameters are immediately effective!
The process is directly affected by these changes.
Î First check any changes made to parameters before conrming them by pressing the ro-
tary pushbutton.
6.1.3 Keys on version with three-key operation
In the special version with three-key operation, the actuator is operated using three keys on
the cover:
Select/changecodesandvalues(increasevalue)
Conrmsetting/change
Select/changecodesandvalues(reducevalue)
The operation and setting of the Type3375 Actuator is described in these Mounting and Op-
erating Instructions based on the version with rotary pushbutton.
Pressing keys
and corresponds to turning the rotary pushbutton and the key corre-
sponds to pressing the rotary pushbutton of the standard actuator version.
NOTICE
!
Note