Samson 3374 Series - End Position Guiding; Operating Direction Increasing;Increasing; Direction of Action: Increasing;Decreasing

EB 8331-4 EN 5-15
Installation
5.7.2 Connection for special
version with three-key
operation
Perform electrical connection for the special
versionofType3374withthree-keyopera-
tion as follows:
Î RefertoFig.5-18.
1. Unthread the four fastening screws of the
housing cover. Lift off the housing cover.
Î Make sure the connecting cables (1) of
the housing cover are not damaged by
tensile load.
2. Move the housing cover to the position
asshowninFig.5-18:
3. Placeoncover.Brieyturnthescrew(2)
counterclockwise to center it. Tighten it
slightly.
Î Make sure that the screw is not screwed
all the way into the thread. Otherwise,
the cover seal may become damaged.
4. Connect the wiring as shown in
Fig.5-11.
5. Loosen the screw (2), while holding the
housing cover to ensure the connecting
cables (1) of the housing cover do not
get damaged by tensile load.
6. Place the housing cover on the housing
and route the connecting lines in the
housingasshowninFig.5-18.
Î Make sure the connecting cables of the
housing cover do not get jammed.
7. Brieyturnthefasteningscrewscounter-
clockwise to center them. Then fasten
down the cover by tightening the screws.