Samson 3374 Series - Restarting the Actuator (Reset); Reset to Default Settings; Testing the Display

8-10 EB 8331-4 EN
Operation
Î Initialization can be canceled at all times by selecting ESC.
8.4.3 Restarting the actuator (reset)
The actuator can be restarted by performing a reset. Upon restart, the actuator goes into the
operatingmodepreviouslysetunlessadifferentrestartconditionhasbeendened(seethe
'Start-upandconguration'section).
Code Description Adjustment range
d53 Perform reset RES
8.4.4 Reset to default settings
Alltheparametersofthecongurationlevelcanberesettotheirdefaultsettings(WE).
Code Description Adjustment range
d54 Load default settings in actuator DEF
8.4.5 Testing the display
All the segments of the display are shown during the display test when a display functions
properly. The display test is performed by selecting Code d55 in the service level (Code 20).
Code Description Adjustment range
d55 Testing the display TEST (all segments displayed)
Activate display test (service level/Code 20)
1. Turn
(when the start screen appears) to select Code d55
(display: TEST).
2. Press to start test.
Î All segments are shown.
%
S
mm
%
mm
3. Press to hide all segments (backlight remains switched on)
4. Press
again to return to the d55 TEST reading.