Samsung OfficeServ 100 - System a Programming

CHAPTER 10. Networking Description and Programming Procedure
10-16 © SAMSUNG Electronics Co., Ltd.
10.3.1 System A Programming
Program 820 Set System Link Number (MCP1)
Index Link ID Signal G/W 
SELF 091 168.219.100.100

SYS01 092 168.219.110.110

SYS02 093 -  Unnecessary because it is
connected only to PRI.
SYS03 094 168.219.120.120

Program 821 Set Networking trunk line
Set TEPRI card connected with System B, or C as Q-Signaling.
Program 724 Change Dial Numbers (MCP1)
STN Dial Number Set the extension number as 2000~2099.
STNG Dial Number Set the extension group number as 5000~5079.
TRKG Dial Number Set 800, 801, 802, and 803.
FEAT Dial Number Set LCR as 9 To make trunk line call, dial 9 and the
target telephone number.
NTWK LCR Dial No IDX-01: 21 Is converted to 2100~2199 call number in 824.
IDX-02: 22
IDX-03: 23
IDX-04: 24
IDX-05: 25
IDX-06: 26
IDX-07: 51
IDX-08: 52
IDX-09: 53
Program 824 Convert Auto Route Selection Expansion Dial
Index Phone No. Converted No. SZ Max DISP MB

01 21 09221 4 7 Y Y
 The station call of the system B
02 22 09222 4 7 Y Y
03 23 09223 4 7 Y Y
04 24 09324 4 7 Y Y
 The station call of the system C
05 25 09325 4 7 Y Y
06 26 09426 4 7 Y Y
 The station call of the system D
07 51 09251 4 7 Y N  The station group call of the
system B
08 52 09352 4 7 Y N  The station group call of the
system C