OfficeServ 100 Installation Manual/Ed.00
© SAMSUNG Electronics Co., Ltd. VII
Caution
When installing appropriate batteries
Be sure the polarity is observed. Equipment damage will result if polarity is
reversed. Do not connect external AC/ DC power to the OfficeServ 100 system if
the system is damaged by electrical power.
Before installing OfficeServ 100
Unpack and inspect each card before installing. Check for signs of physical
damage. If any damage is detected, do not attempt to install. Contact Samsung
Technical Support immediately.
When using extension cords(A direct commercial AC power outlet)
A direct commercial AC power outlet is required. Do not use extension cords.
Preferably, a dedicated circuit must be used to minimize the risk of other electrical
equipment being connected that could adversely affect system operation.
When installing OfficeServ 100
Ensure that all wires and cable going to and coming from the OfficeServ 100 are
properly routed. Do not cross fluorescent lights or connect lines parallel to the AC
power line.
Connecting equipment
Do not attempt to connect commercial AC power to the contacts on the DPIM,
External Paging, and Common Bell. It may cause damage to your equipment.
CAUTION
To Next Page
Loading...
