Santec MPM-210H - Page 35

MULTI-PORT OPTICAL POWER METER MPM-210H
35 / 59
Measurement Mode (SWEEP1, SWEEP2)).
Syntax
SPE?
Response
<value>
Sweep speed – 0.001 ~ 200
Unit: nm/sec
Example
SPE?
Response: 1
13. LEV
Description
Set up TIA Gain for CONST1, SWEEP1, FREERUN, AUTO1
measuring mode.
Refer to the 5.5.7 for the relation between the gain setting
and the input power.
This command is not available for the MPM-215.
Syntax
LEV<wsp><value>
Parameters
<value>: 1, 2, 3, 4, 5
In case of the MPM-213 (current meter), the available
range is 1 to 4.
Default
value: 5
Example
LEV 5
14. LEV?
Description
Check TIA Gain of CONST1, SWEEP1, FREERUN, AUTO1
measuring mode.
Refer to the 5.5.7 for the relation between the gain setting
and the input power.
This command is not available for the MPM-215.
Syntax
LEV?
Response
<value>
value: 1, 2, 3, 4, 5
Example
LEV?
Response: 5
15. DLEV
Description
Set up TIA Gain for CONST1, SWEEP1, FREERUN, AUTO1