Santec MPM-210H - Page 38

MPM-210H OPERATION MANUAL
38 / 59
21. UNIT
Description
Set measuring unit of optical power or electrical current.
Syntax
UNIT<wsp><value>
Parameters
<value>
0 – dBm, dBmA
1 – mW, mA
Default
value: 0
Example
UNIT 0
22. UNIT?
Description
Check measuring unit of optical power or electrical current.
Syntax
UNIT?
Response
<value>
0 – dBm, dBmA
1 – mW,mA
Example
UNIT?
Response: 0
23. AUTO
Description
Set the power range (Auto or Manual).
It is available for the “READ?” command.
Syntax
AUTO<wsp><value>
Parameters
<value>
0 – Manual range
1 – Auto range
Default
value: 1
Example
AUTO 1
24. AUTO?
Description
Check the power range (Auto or Manual).
It is available for the “READ?” command.
Syntax
AUTO?
Response
0 – Manual range
1 – Auto range