Sanyo PLC-XU301A - Page 52

52
Standby mode
Thisfunctionisavailablewhenoperatingtheprojectorvia
network.
 Network.... Supplythepowertothenetworkfunctioneven
afterturningofftheprojector.Youcanturnon/
off the projector via network, modify network
environment, and receive an e-mail about
projectorstatuswhiletheprojectorispowered
off.
 Eco............ SelectEcowhenyoudonotusetheprojector
via network. The projector’s network function
willstopwhenturningofftheprojector.
Refertotheowner’smanual“NetworkSet-upand
Operation”.
Note:
•FactorydefaultisNetwork.
•WhenselectingNetwork,thecoolingfansmayberunning
dependingonthetemperatureinsidetheprojectorevenif
theprojectoristurnedoff.
Setting
On start
WhenthisfunctionissettoOn,theprojectorwillbe
automaticallyturnedonjustbyconnectingtheACpower
cordtoawalloutlet.
Note:
  Be sure to turn off the projector properly (see “Turning
OfftheProjector”onpage20).Iftheprojectoristurned
offintheincorrectsequence,theOnstartfunctiondoes
notworkproperly.