Sanyo PLC-XU301A - Page 51

51
Setting
Power management
TimeleftbeforeLampisoff.
Power management
Forreducingpowerconsumptionaswellasmaintaining
thelamplife,thePowermanagementfunctionturnsoffthe
projectionlampwhentheprojectorisnotoperatedfora
certainperiod.
Selectoneofthefollowingoptions:
Ready...............  Whenthelamphasbeenfullycooled
down,thePOWERindicatorchanges
togreenblinking.Inthiscondition,
theprojectionlampwillbeturnedonif
theinputsignalisreconnectedorany
buttononthetopcontrolorremote
controlispressed.
Shut down.......  Whenthelamphasbeenfullycooled
down,thepowerwillbeturnedoff.
Off....................  Powermanagementfunctionisoff.
Timer................  Iftheinputsignalisinterruptedand
nobuttonispressedformorethan
30seconds,thetimerdisplaywith
No signalappears.Itstartsthe
countdownuntilthelampisturnedoff.
UsethePoint▲▼buttonstosetthe
Timer(1~30min).
Note:
 FactorydefaultisReady: 5 min.
Closed caption
Ready
No signal
04 : 50