Sanyo PLC-XU301A User Manual

65
Appendix
No image –Checktheconnectionbetweenyourcomputerorvideoequipment
  andtheprojector.Seepages14-16.
 –Seeiftheinputsignaliscorrectlyoutputfromyourcomputer.Some
  laptopcomputersmayneedtochangethesettingformonitoroutput
 whenconnectingtoaprojector.Seeyourcomputer’sinstruction
  manualforthesetting.
 –Ittakesabout30secondstodisplayanimageafterturningonthe
  projector.Seepage18.
 –ChecktheInputsignal,colorsystem,videosystemorcomputer
systemmode.
 –MakesurethetemperatureisnotoutofthespecifiedOperating
  Temperature(41˚F–95˚F[5˚C–35˚C]).
 –WhenNo Showisoperating,theimagecannotbedisplayed.Press
  theNOSHOWbuttonoranyotherbuttonontheremotecontrol.
No sound –Checktheaudiocableconnectionfromaudioinputsource.
 –Adjusttheaudiosource.
 –PresstheVolume+button.Seepage24.
 –PresstheMutebutton.Seepage24.
 –WhentheAUDIOOUTisplugged-in,theprojector'sbuilt-inspeaker
  isnotavailable.      
 –Istheimageprojected?Youwillhearthesoundonlywhentheimage
 isprojected.
The color is strange. –ChecktheInputsignal,colorsystem,videosystemorcomputer
  systemmode.      
 –MakesuretheBlackboardisnotselectedonImageselect
  menu.Seepages33,40.
Some displays are not seen –ChecktheDisplayfunction.Seepage46.
 during the operation.
 Auto PC adjustment function –ChecktheInputsignal.AutoPCadjustmentfunctioncannotwork
 does not work.  when480p,575p.720p,480i,575i,1035ior1080iisselected.See
 page30.

 The setting does not remain –MakesureyouselectedStoreafteradjustingsetting.Somesettings
 after turning off power.  cannotbestoredifnotregisteredwithStore.Seepages35,42.
 Power management does not–PowermanagementfunctioncannotworkwhileFreezeorNo
work.  Showfunctionisrunning.Seepage51.
 Capture function does not work.–Checktheconnectionandtheinputsignaltoseeifthereissignal.
 Auto setup does not work properly.–
MakesureOffisnotselectedatanyfunctionof Auto setup.Seepage 
  45.
 –MakesureOnisnotselectedattheCeilingfunction.Seepage50.
Auto keystone function does not –MakesuretheAutokeystonefunctionisnotsettoManual.Press
 work even when the projector is theAUTOSETUPbuttononthetopcontrol.Seepages23,45. 
tipped. 

Sanyo PLC-XU301A Specifications

General

Brand	Sanyo
Model	PLC-XU301A
Category	Projector
Language	English