Sanyo PLC-XU301A User Manual

66
Appendix
The image is distorted or runs off. –CheckPC adjustmenuorScreenmenuandadjustthem.
 Seepages31-32,35-36.
PIN code dialog box appears –PINcodelockisbeingset.EnteraPINcode(the“1234”ornumbers
 at start-up.  youhaveset).Seepages19,54-55.
The Remote Control does –Checkthebatteries.
 not work. –Makesurenoobstructionisbetweentheprojectorandremote
 control.
 –Makesureyouarenottoofarfromtheprojectorwhenusingthe
  remotecontrol.Maximumoperatingrangeis16.4'(5m). 
 –Makesurethecodeoftheremotecontrolisconformedtothe
  projector’scode.Seepage53.
 –UnlocktheKeylockfunctionfortheremotecontrolfunction.See
  page54.
 Indicator blinks or lights. –Checkthestatusoftheprojectorwithreferringto"Indicatorsand
projectorCondition".Seepage70.
 The exclamation mark appears–Youroperationisinvalid.Operatecorrectly.   
on the screen.
Top control does not work. –ThetopcontrolisnotavailableifthetopcontrolislockedatKey lock

 underSecurityofSETTINGsection.Seepage54.
 Unable to unlock the Logo PIN–Contactthedealerwhereyoupurchasedtheprojectorortheservice
 code lock, Security key lock  center.       
 or Security PIN code lock.

Sanyo PLC-XU301A Specifications

General

Brand	Sanyo
Model	PLC-XU301A
Category	Projector
Language	English