Operating Instructions Combics CAIXS2 113
Care and Maintenance
Cleaning the Stainless Steel Surfaces
– Only use conventional household cleaning agents that are suitable for stainless
steel.
– Only use solvents for cleaning stainless steel parts.
t All stainless steel parts should be cleaned at regular intervals: Rub stainless
steel surfaces with a moist cloth, with a cleaning agent if required, then remove
all residue from the surface.
t Allow device to dry. For additional protection, protective oil may be applied.
Replacing the Dust Cover
Damaged dust covers should be replaced immediately.
t Remove damaged dust cover.
t Place the new dust cover on the indicator and press it over the edge of the
front and rear side of the device until it is fixed in place.
Safety Inspections
Safe operation of the device is no longer ensured when:
– there is visible damage to the device or power cord
– the integrated power supply for the indicator no longer functions properly
– the device has been stored for a relatively long period under unfavorable
conditions (e.g. excessive humidity)
If there is any indication that safe operation of the device is no longer warranted:
t Disconnect the power supply to the device (unplug the power cord from the
mains supply) and make sure the device cannot be used for the time being.
t Notify your nearest Sartorius Service Center.
Maintenance and repair work may only be carried out by service technicians:
– who have access to the required maintenance manuals
and
– who have attended the appropriate training workshops.
h
The seals on the device indicate that the device may only be opened and
maintained by authorized specialist personnel, so that the correct and safe
operation of the device is ensured and the guarantee remains valid.
To Next Page
Loading...