56 Operating Instructions Combics CAIXS2
Operation
Neutral Measurement Z nM
With this application you can measure the length, surface and volume of parts that
have roughly the same specific weight. The o symbol is displayed as the unit (menu
APPLIC.1).
Features – Save the reference weight “wRef" from the weighing platform.
– Enter the reference weight “wRef" using the keypad.
– Enter the factor for calculation “nRef” using the keypad.
– Measuring with two weighing platforms.
– Activate Info mode with the I key.
– Toggle the display between measurement and weight using the w key.
– The level of accuracy (display resolution) can be set when the calculated
reference weight is applied.
– Automatic taring of container weight.
Setting: Applic./aut.tare, menu item 3.7.
– Automatic initialization when the scale is switched on. The indicator is
initialized with the most recently used values for reference sample quantity
“nRef” and reference sample weight “wRef.”
Setting: Applic./aut.strt, menu item 3.8 .
Exit Application, Delete Parameters
The value of the reference sample weight in the reference memory remains active
until it is deleted using the c key, or is overwritten, or until the application is
changed.
The reference sample weight also remains saved after the scale is turned off.
You can assign different functions to the c to delete applications. When you
clear applications, you can delete either the data stored for all applications or just
selected data stored for the active application.
Setting: APPLIC/CLER.CF menu item 3.24.
Tare Function:
If you store a tare (weight value) by pressing the ) key, you can later enter a tare
value manually. The tare value you enter is added to the stored tare value.
Setting: APPLIC./TARE.FNC menu item 3.25.1 (factory setting).
A tare value entered manually overwrites a stored tare value (weight value). If you
enter a tare value manually, a tare value (weight value) stored later overwrites the
manually entered value.
Setting: Applic./TARE.FNC menu item 3.25.2.
Restore factory default settings: Applic./Reset menu item 9.1.
Reference Weight
In order to calculate the length, surface or volume of a given sample, the average
weight of a reference quantity of the sample must be known (in the example below,
the reference is 1 meter of electrical cable). There are different ways to enter the
reference weight:
Calculating the Reference Weight
- Place the reference quantity (defined by the calculation factor) on the
connected weighing platform and calculate the reference sample weight by
pressing the O key.
or
- Place any amount of the sample material on the connected weighing platform,
enter the calculation factor through the keypad, and press the r key to
calculate the reference sample weight.
To Next Page
Loading...