SATO S84 ex - Removing the Housing Cover; Opening the Rear Housing Cover

5 Replacement
56
S84-ex/S86-ex Service Manual
5.1 Removing the Housing Cover
Before you remove the covers of the printer, power off the printer. Disconnect the power cord and all
cables attached to the printer.
5.1.1 Opening the Rear Housing Cover
Required tool:
• Phillips screwdriver
1 Make sure that the printer is in power off
mode, then disconnect the power cord
from the AC outlet.
2 Loosen and remove two flat-head
screws  at the top of the rear cover, then
remove another two pan head screws 
at the rear.
3 Open the interface side of the rear
housing cover
 and then open the other
side that has a flap on the rear housing
cover
.
4 Perform the assembly, close the rear
housing cover  with the reverse
procedure.
Close the rear housing cover with a flap  first
and then the other side
.
1
2
34
flap